Instruction Manual

30
Customer Helpline 0345 605 2063
Suspected malfunctions are often due to causes that the user can x themselves.
Therefore, check the product using this section. In most cases the problem can be solved
quickly.
WARNING! Only perform the steps described within these instructions! All further
inspection, maintenance and repair work must be performed by an authorised service
centre or a similarly qualied specialist if you cannot solve the problem yourself!
Gloves and appropriate protective clothing must be worn when performing these
instructions.
The following table provides solutions to common problems encountered with the hover.
Troubleshooting
General Troubleshooting
Fault Possible Cause Solution
Hover does not start No power at mains socket. Check the fuse, switch,
socket, cable, wire and have
any repairs carried out by a
qualied electrician.
Defective on/off switch. Repair by a qualied
technician required.
Defective motor.
Motor starts and stops
immediately
Airow to the impeller is
blocked by grass.
Disconnect from mains.
and clean the deck and the
impeller.
Poor collection
Cut grass length too long. Raise the cutting height.
Grassbox tted incorrectly. Fit the grassbox correctly.
Mowing in side to side
movements.
The hover collects at the rear
as users walk forward in straight
lines.
Excessive vibration
Blade damaged. Replace blade.
Blade tted incorrectly. Fit the blade correctly.
Impeller Damaged. Replace Impeller.