Instruction Manual

Customer helpline 0345 605 2065

Operate

Operating instructions

6. WHEN REFITTING THE SPOOL CAP.

Keep all areas of the cap and spool holder clean.

Ret the cap, pressing rmly down towards the spool holder to ensure cap is fully located.

Check that the cap is correctly tted by trying to remove it without depressing the two latches.

7. TO REPLACE CUT LINE.

For your convenience it is recommended you buy spool and line complete.

-- TO FIT SPOOL AND LINE COMPLETE:

1) Remove old spool.

2) Place new spool into cutting head. Release one line from cleat and feed line through eyelet.

3) Repeat for second line.

4) Ret the cap.

-- TO FIT NYLON LINE ONLY:

WARNING!

Your trimmer is designed to use only line with a maximum diameter of 1.65 mm.

IMPORTANT - ALWAYS WIND THE LINE ONTO THE UPPER SECTION OF THE SPOOL FIRST.

1) Take a line of approximately 3m. (Fig. N1)

2) Insert 15mm of line into hole in the spool and wind line in the direction of the arrows on the top of the

spool (Fig. N2).

3) Leave approximately 100mm of line unwound and place into cleat (Fig. N3).

4) Then t spool as described in “TO FIT SPOOL AND LINE COMPLETE”.

Care should be taken to ensure that the line is neatly coiled on the spool. Failure to do so will impair the

efciency of the automatic line feed.

N1 N2