Installation Manual

8
MN-333
11. Recheck air pressure after 24 hours. A 2–4 PSI loss after initial installation is normal.
If pressure has dropped more than 5 PSI, re-test for leaks with soapy water solution.
Please read and follow the maintenance and operating tips in the installation manual
that came with your air spring kit.
IMPORTANT: If the compressor runs continually or often, then there is a leak. Disconnect
the compressor at the fuse box and test for leaks with a soapy water solution.
NEVER RUN THE COMPRESSOR LONGER THAN FOUR MINUTES CONTINUOUSLY.
ALLOW AT LEAST FIVE MINUTES FOR COOL DOWN BEFORE STARTING THE
COMPRESSOR AGAIN.
CAUTION
Load Controller II