User`s manual
mcdsp.com
Page 30
Chrome Tone
User’s Manual
Chrome Tone Specifications Chorus
Parameter Settings Function
CHORUS TYPE Flange, Chorus 1, Chorus
2, Analog Delay (in Stack
conguration only)
Selects between Flange, Chorus 1, and Chorus 2 modes. In the Stack conguration, an Analog Delay mode is also
available for up to 1 second of analog delay.
DELAY 0 to 100 The total delay line lengths used to create the delay modulated effect
FEEDBACK -100 to 100 Amount of delayed signal feed back into the input of the delay line/s
MIX 0 to 100 Balance between the dry (un-delayed) and wet (delayed) signals
RANGE 0 to 100 Overall modulation range from both the Dynamic and Auto sections
Chrome Tone Specifications Tremolo
Parameter Settings Function
MIX 0 to 100 The amount of dry (unaffected) signal and wet (tremolo’d) signal
RANGE 0 to 100 Overall modulation range from both the Dynamic and Auto sections
Chrome Tone Specifications Wah
Parameter Settings Function
WAH TYPE 3 wahs, 3 low pass, 3 high pass,
3 phasors, wah + low pass,
high pass + wah, experimental,
12/24/36 dB per oct in each set
of lter types
14 lter options: 3 types of band pass wah including the standard wah lter type found on many Wah pedals, 3 high
pass lters (12, 24, and 36 dB/oct), 3 low pass lters (12, 24, and 36 dB/oct), 3 phasors (2, 4, and 6 stages), a wah plus
low pass lter, a high pass plus wah lter, and an experimental wah lter
FREQ 0 to 100 Frequency of the selected lter type. From this value the modulation of the frequency is initiated
Q 0 to 100 Resonance, or peak-emphasis, of the selected lter
RANGE 0 to 100 Overall modulation range from the Dynamic and Auto sections