User manual

Page 18
PARAMETER SETTINGS FUNCTION
EQUALIZER (LOW SHELF, PARAMETRIC, HIGH SHELF)
GAIN -12 to +12 dB Boost or cut to selected frequency region.
FREQ 40 to 400 Hz
0.40 to 4.00 kHz
4 kHz to 15 kHz
Low Shelf
Parametric
High Shelf
DISTORTION
DRIVE 0 to 12 dB Amount of gain (emphasis) of selected
FREQ in distortion circuit.
DRIVE TYPE
(POPUP)
Normal, Wide, Low and
various Filters
Controls and shapes the frequencies that
feed the distortion circuit .
FREQ 200 to 2000 Hz Frequency where the DRIVE control gain
is focused.
AMOUNT 0 to 100 Amount of distortion. Yellow LED lit when
distortion circuit is active.
LEVEL -48 to 0 dB Overall output level of the distortion
section.
TYPE
(POPUP)
Light, Light II, Medium,
Heavy, Shread, and Screamer
Selects the distortion circuit type, from
light distortion to full shred.
OUTPUT
REVERB 0 to 100 Amount of reverberated signal mixed with
the dry signal.
CABINET TYPE
(POPUP)
1x12, 2x12, 4x10, and 4x12,
varied styles, and two direct
modes
Several different cabinet styles with close
and room microphone positions, plus
direct modes with no cabinet modelling.
The settings containing the indication `II’
are derived from closed-back cabinets (the
settings without indication are derived
from open backed cabinets)
Ø (PHASE) ON/OFF Polarity (phase) of the nal output, ON is
180° from original.
OUT -24 to +24 dB Overall signal level adjustment. LED Meter
lit to show output level.