Technical information

APPENDIX 12
The display area shows the transfer function of both the Expander/Gate and
Compressor/Limiter, and the frequency response of the Filter section. Two small
buttons to the left of the display allow the user either to view these graphs, or
to view a signal  ow diagram that shows the internal signal routing paths. To
the left of the display there is an Input level control and to the right there is an
Output level control, together with a phase reversal buttons for each channel.
Centrally located just below the main display area, a set of meters displays
the input and output levels, the Compressor/Limiter gain reduction, and the
Compressor/Limiter output levels.
To the right of the meters, there is a full-featured four-band parametric EQ,
identical to the one found in the original Channel G (save the removal of the
MF band and dedicated  lters). The LF and HF bands of the EQ also have type
controls used to switch the EQ type between parametric and shelf shapes.
There are peak indicators for the EQ bands to show when signal levels are at
maximum. A bypass control for the entire EQ section is also provided.
the Channel G Compact to suit this. Channel G Compact also works nicely with
the VENUE console.
Channel G Compact includes a Compressor/Limiter section, a pair of high-pass
and low-pass  lters, separate input and output controls, and a large graphic
display area.
Figure A12.30
Channel G Compact.