Technical information

McDSP plug-ins
controls to display – Gate, Expander, or Compressor – with a small bypass
button for each processor located underneath these selector buttons.
Multi-band Control Linking
Controls in each band can be linked by  rst selecting the bands to be linked
using the blue “L” on either the Main or Crossover meter page. A master band
to which all other bands are linked can then be selected by pressing the yellow
‘M’ button, located just above the blue ‘L’ button. Note that there can only be
one master band at any one time. To deselect a band as the master, simply
press the ‘M’ button again, or choose another band as the master band.
Once a master band and linked bands are selected, the Gate, Expander, and
Compressor controls for those bands establish and retain relative o sets from
each other, and allow multiple bands to be altered via the master band. The
linked band controls may still be moved, and can be operated independently
of the master band.
When automating the ML4 and using multi-band control linking, it is usually
best to automate the controls in the master band. The linked bands will then
follow the master band automation. If the linked bands are also automated,
their automation data will ‘fight’ against the automation data and linked
control changes received for the master band.
Figure A12.23
ML4000 ML4
Multi-band Dynamics
Processor crossover
display.