User manual

CONFIGURATOR :: PC tool Operating guide for Alarm Receiver Exprecium D 20|52
MCDI SECURITY PRODUCTS INC. 7055 Jean-Bourdon Montréal Québec Canada +514.481.1067 www.mcdi.com [e-mail]
MAINTENANCE TAB Parameters in the maintenance tab are to set time and date, com speed, reset, and
firmware update.
Maintenance tab description
Adjust time and date
If the time and date should not be synchronized with PC time, you can enter time and date manually.
Press on Apply to send new Time and date to Ed.
Adjust communication speed
Synchronization of speed is typically needed with most automation software. Select speed in
bauds from 1200 to 115200. Select accordingly in automation software.
Configuration Apply factory default To reset Ed to factory default, select either L1,L2 for receiving parameters or Output
for output formatting and press Apply. See default parameters list above.
Update firmware
Use only under MCDI Guidance. This is to update receiving section providing communication is established
between PC and Ed. If communication is not established, Ed cannot be reprogrammed this way.
NOTE: Ed will not be available when update is being made. This may take up to 2 minutes.
NOTE: This procedure does not affect display programming which requires a different programming and connecting a ATMEL
AVRISP programmer. Contact MCDI if you need to reprogram display.
NOTE: This procedure does not affect Boot loader. Reprogramming Boot loader requires making a short circuit on specific parts
and reprogramming over USB or special internal debug port. This reprogramming requires MCDI guidance.
STATUS TAB shows key parameters in literate form. They are the same as status icons at bottom of configurator or on
front display. There are no write fields in this page:
Typical:
Line 1: Connected Power: Main
Line 2: L2 Connected Battery: 100%
PC1: USB Disconnected Printer: Connected
PC2: Serial connected Power: Main
Unit name: Exprecium D (typical)
Owner: selected name
Firmware: Exprecium D: vx.x.x
Possible status
L1/L2: Connected / disconnected / Busy (receiving)
PC1: USB connected / USB disconnected
PC2: Serial connected / Serial disconnected
Power: Power connected / Power disconnected
Battery: 0% /25% /50% /75% /100%
Printer: Connected / Disconnected
Unit name: as selected in General tab
Owner's name: as selected in General tab
NOTE: Firmware level for display programming is only available from the Status menu of Front display.