User manual

CONFIGURATOR :: PC tool Operating guide for Alarm Receiver Exprecium D 19|52
MCDI SECURITY PRODUCTS INC. 7055 Jean-Bourdon Montréal Québec Canada +514.481.1067 www.mcdi.com [e-mail]
Display tab description:
Configurator language Select configurator language. If you don’t see your language, it is possible for supply a
translation to MCDI for recompiling for you.
N.B.:
Language of front display refers to D4. Not applicable to Ed. Select from English, French, German, Italian, Portuguese,
Russian and Spanish. Other languages may be available in the Configurator. You can use one language in Configurator while
another one is used in Front Display of D4. Display language does not change alarm events.
Idle mode refers to Event viewing mode in D4 and not applicable to Ed. Sets the operation mode for viewing current events out
of the event logs. Select from Last event/time, Keep last event mode or Manual mode. A viewing mode must be predefined.
Last event mode: new event will be presented automatically during 10 seconds. D4 will return to idle menu after 10s.
Keep last event mode: a new event will be displayed. D4 will not return to idle menu unless enter or escape keys
are pressed. Any new event received will replace the one on current display
Manual mode: a new event will be displayed. NO new event will be display unless enter of escape keys are pressed.
Returning to idle menu will require acknowledge (Enter/CR) of every event not acknowledge.
REFER TO EVENT VIEWING SECTION ABOVE FOR COMPREHENSIVE DESCRIPTION OF VIEWING EVENTS
ON FRONT DISPLAY.
Time and date format
Set display of time and date to one of the following:
DDMMYY_HHMMSS 12H
YYMMDD_HHMMSS 12H
MMDDYY_HHMMSS 12H
DDMMYY_HHMMSS 24H
YYMMDD_HHMMSS 24H
MMDDYY_HHMMSS 24H
NOTE: This selection only refers to date and time display from D4 and not to events formatting or reporting to PC.
LEDS Some lights are continuously flashing to warn user. It is possible to deactivate functioning of a LED if not pertinent or
annoying. For example if you are only using one phone line, you may deactivate LED of the second line as it will blink
continuously.
Select to enable/disable Line 1, Line 2, PC (PC absence/presence), POWER
NOTE: deactivating a LED will not deactivate the function.
NOTE: deactivating a LED will not deactivate the status icon which will display fault permanently