Installation guide

Page 9
Installation guide for Alarm Receiver Exprecium
MCDI Inc. Internet: http://www.mcdi.com
86 Claude-Champagne Avenue, Montreal, QC, Canada H2V 2X1 Telephone: [phone] Fax: [phone]
By default the Exprecium
does not verify printer status on parallel port but sends data to be printed as if
a printer was connected to this port.
(Yes) option tells the Exprecium receiver to verify and report on the status of the printer connected to
its parallel port. A connector is supplied to daisy chain multiple receiver cards ( Exprecium, TLR+
or TLR ) in the same computer to send all output to one printer only.
When Check printer option is enabled (Yes) and the computer is absent, each event being sent to
printer triggers a warning buzzer. This warning sound may be stopped by clicking twice the ON-LINE
printer key. Buzzing resumes if printer is left Off-line.
Do not set the "Yes" parameter if no printer is installed. Multiple error messages could be generated
by taking this action.
Start handshake with 1 1400hz / VFSK
2SIA / CFSK
3 DUAL 1400hz / 2300hz
4 2300hz
5STRATEL
6TELIM
7ROBOFON
Default sequence is as above. Option is to change first element with the one selected.
Extreme care must be exercised when changing Handshake sequence. It is a well known fact that
many dialers do not respond well to all startup sequences.
Wait after O/H Delay to start Handshake after Off Hook. No = normal, Yes=5 seconds
Caller ID PC No = Do not send telephone ID data to PC
Yes = Send telephone ID data to PC
Caller ID PRN No = Do not send telephone ID data to the Exprecium printer port
Yes = Send telephone ID data to the Exprecium printer port
Caller ID ALL No = Do not send telephone ID data except when bad transmission occurs
Yes = Send telephone ID data to PC and Exprecium printer port unless PRN and PC select otherwise
Date / Time Yes = enable No = disable
Send year Yes = Date including the year No = Date with out year
Yes, tells the Exprecium to add the Year in date format: HH:mm _ _ MM/DD[/YY] ...
No,tells the Exprecium to use date and time format: MM/DD.
ACK delay Wait time in seconds for ACK reception before resend. (Surgard/Native mode only)
1 to 9 1= default
Surgard Mode Yes = enable No = disable
SAMM
Automation software Section
Keep receiver number No = default YES = Insert receiver # in front of account #
Keep line number No = default YES = Inset line # in front of account #
Offset 0 (zero) = default Insert digit 0 to 9 or letter A to F in front of account #
Compress Contact ID No = default YES = Use Compress Contact ID instead of standard one
Connectors, leds and Jumpers - Main board
J1 External battery connector 6 - 12 votls
J2 Connector port for IBM compatible parallel printer type DB25. When more than one card is installed in the same computer,
one printer can be used for all cards in the same computer, instead of one printer per receiver card. See TX1,RX1 below.
J3 PCI bus connector
JP1 Future use