Installation guide

Page 13
Installation guide for Alarm Receiver Exprecium
MCDI Inc. Internet: http://www.mcdi.com
86 Claude-Champagne Avenue, Montreal, QC, Canada H2V 2X1 Telephone: [phone] Fax: [phone]
T:Type(E or R) (Contact ID)
Ø:Zero
<CR> :EOS (Carriage Return)
<ACK> : Data retransmits to computer every 2 second until ACK is received (ACK=06H or $06).
@:Heartbeat signal Receiver Option)
t...t : Telephone number from Caller ID
[:Beginning data delimiter (SIA)
]:Ending data delimiter (SIA)
|:Field separator (SIA)
#:Account ID block code (SIA)
E:Function block code (SIA)
/:Data code packet separator (SIA)
<LF> : Line Feed
EXPRECIUM Error and Warning messages sent to Printer port and PC:
HH:MM MM/DD[YY] RL Account XYY
Printer message Time Date Receiveraccount 01 Printer error
Time Date Receiveraccount 02 Printer reset
Telephone line monitoring Time Date Receiver account 03 Error Line 1
Time Date Receiveraccount 04 Reset Line 1
Telephone line monitoring Time Date Receiver account 05 Error Line2
Time Date Receiveraccount 06 Reset Line2
External battery backupTime Date Receiveraccount 07 Low external battery
Time Date Receiveraccount 08 Normal external battery
Transmission message Time Date Receiver 0000 00 Bad transmission
Time Date Receiver[#0000|A BAD TRANSMISSION]Format SIA
No Transmission Time Date Receiver 0000 F1 No signal received Line 1
Time Date Receiver 0000 F2 No signal received Line 2
Transmission to computer and printer in ADEMCO 685 / Surgard emulation mode
User Manual : for information on transmission See ADEMCO 685 standards
User Manual : for information on transmission See Surgard MRL2 documentation
Surgard emulation applies to Dial up Alarm signals and Telephone ID
Messages from EXPRECIUM
printer port:
When computer ceases to communicate, "Computer absent" message is sent to the Exprecium printer port
When computer resumes communication, "Computer restore" message is sent to to the Exprecium printer port
Transmission rate
1200 bps, no parity, 8 bits, I stop bit