User manual

DESCRIPTION Page 4 | 41
Operating guide for Alarm Receiver DECRYPTA
3
MCDI Security Products Inc.. Internet: mcdi.com
7055 Jean-Bourdon Avenue, Montreal, QC, Canada H4K 1G7 Telephone: [phone] Fax: [phone]
REAR PANEL DESCRIPTION
USB PORT
Type B USB connector. USB client to host cable supplied
SERIAL NUMBER TAG
All DECRYPTA
3
serial number contain 8 digits. Please
quote serial number in emails or when calling for support to
speed up identification process. Serial number appears in
configuration tool when using USB output.
SERIAL (DB9 male connector)
Data transfer to computer:,
Null modem cable supplied (DB9F to DB9F)
Serial port: 1200 Baud, 8 bit, 1 stop bit
Pin 2 = transmit
Pin 3= receive
Pin 7 = ground
RELAY TERMINAL 2 POSITIONS.
Terminal block used for trigger of external unit by inboard relay
( 30V DC 1A max). Supports normally open or normally closed.
GROUND POST
Used to mechanically ground the unit. Refer to Electrical feed
for more details.
POWER SUPPLY INPUT (SPU15A-104 )
100-240VAC to 9VDC 1.66A supplied with D
3
BATTERY INPUT
12 VDC
Supplied battery connector red = + black = -
Refer to section Electrical feed before using.
PRINTER (DB25 female connector)
Printer parallel port. Raw signals received by D
3
.
LINE 1, LINE 2
Incoming phone lines
Tip
Ring
Powering DECRYPTA
3
receiver
In this section
Electrical inputs
Notes on electrical installation for DECRYPTA
3
Alternative power source 9-12V DC
USB Hub
Ground post
Using a battery charger
Warnings
ELECTRICAL INPUTS
DECRYPTA
3
can be powered from:
1.Power Supply Input ( 9 VDC adaptor supplied )
and / or
2.Battery Input ( 12VDC ) using supplied cable
1. DE C R Y P T A
3
powered from the POWER SUPPLY INPUT
DECRYPTA
3
can powered from the 9-12VDC only. Minimum requirements 9VDC 500 Ma. Severe damages to the
unit may occur if power supply delivers more than 14VDC.
Power led of front display will be ON steady when the DECRYPTA
3
gets the power from the Power Supply Input.
DECRYPTA
3
is supplied with a 100-240V AC / 9 V DC power adapter. This power adapter is supplied with an IEC
power cord for localization.