User manual

DESCRIPTION Page 31 | 41
Operating guide for Alarm Receiver DECRYPTA
3
MCDI Security Products Inc.. Internet: mcdi.com
7055 Jean-Bourdon Avenue, Montreal, QC, Canada H4K 1G7 Telephone: [phone] Fax: [phone]
Messages from DECRYPTA
3
to DECRYPTA
3
printer port
When computer ceases to answer "Computer absent" is sent to DECRYPTA
3
parallel port
When computer answers "Computer restore" is sent to DECRYPTA
3
parallel port
CARE OF DECRYPTA
3
UNIT:
To clean, always use a slightly damp cloth; never use abrasives or solvents. Avoid pressure, shock, vibration, moisture and
excessive humidity: damage may result. Do not expose to direct sunlight.
Operating condition: 4°C to 40°C.
Storage condition: -15°c to 65°C
Always use with power source as indicated in powering the unit section. Consult a qualified Electrician before using power
sources other than supplied power adaptor.
FIELD REPLACEABLE PARTS (under MCDI SP Inc. direction)
NVRAM units (1).
Phone line interface (red PCB).
Selectable jumpers.
Cables.
FIELD UPGRADABLE (upon MCDI SP Inc. direction)
Firmware programming
Drivers
Communication tools
Enabling DECRYPTA
3
in SAMM (DOS version 8.1.95 and lower)
Due to the nature of USB communication and the limitations of DOS, USB communication can not be established under dos
or with a strictly DOS based application. Serial communication from serial port may be established. Refer to SAMM
installation manual page 6 to establish a start up command string.
USB communication to the Signal logger (CD DECRYPTA
3
>tools/communication/name of logger )can still be
achieved if PC is Windows 98 and up or by sending USB signal to another PC.
Enabling DECRYPTA
3
in SAMM X (version 10.3 or up)
Using WSReceiver.
Enabling DECRYPTA
3
in WinSAMM (version 1.2 or up)
Using WS Receiver
Enabling DECRYPTA
3
in CentralWorks (DOS)
Due to the nature of USB communication and the limitations of DOS, USB communication can not be established under dos
or with a strictly DOS based application. Serial communication from serial port may be established. Refer to Alarmsoft/Jabco
www.alarmsoft.com 1-757-472-4687 for set-up of serial port communication.
USB communication to the Signal logger (CD DECRYPTA
3
>tools/communication/name of logger )can still be
achieved if PC is Windows 98 and up or by sending USB signal to another PC.
Warranty
The Electronic products of MCDI SP Inc. are under a three year limited warranty. Material is repaired or exchanged, free of
charge, when returned to MCDI service points, post and duty paid. Abused or misused equipment is not covered by this
warranty. Damages or loss of business resulting from the use of MCDI products are not covered by this warranty.
Damages resulting from power surge damages are expressly excluded of warranty.
Loss of business, cost incurred during the the use ot MCDI equipment are expressely excluded of warranty.