User manual

DESCRIPTION Page 10 | 41
Operating guide for Alarm Receiver DECRYPTA
3
MCDI Security Products Inc.. Internet: mcdi.com
7055 Jean-Bourdon Avenue, Montreal, QC, Canada H4K 1G7 Telephone: [phone] Fax: [phone]
Starting other MCDI software from Axe Configurator
You can start WinSAMM, WS Receiver, Traffic Logger, or WinCOM from
the Traffic Connect To menu. To set paths to those programs, select
Traffic Settings. The following window will appear where you can
change your settings.
LOGGER TOOL
Logger is a software tool to log to disk DECRYPTA
3
raw output . Logged data may be read by word processors and
Excel for reporting or /and analysis.
REQUIREMENTS
See Axe Configurator tool Java requirements
and installation procedure.
Port:
Choose and connect to the port your receiver
device is attached to.
Interval:
Set interval at which a new log file will be
created. Possible choices are “Hourly”, “Daily”,
“Weekly” and “Monthly”. Consequently, each log
file will contain signals came within an hour, a
day, a week, or a month, respectively.
Day of month, day of week, hour, minute:
Set the exact time when a new log will be
created. The choices available depend on the interval chosen above. For example, if “Hourly” interval is selected,
and the minute is set to “10”, then a new log will be created at 13:10, 14:10, 15:10, 16:10 etc.
NOTE: Every time you change the interval type or its settings, you should reconnect in order for the changes to be
applied.
Log-Directory:
Select the location of the logged signals. The organization of this directory is as follows:
(log-dir) \ (com-port and device name) e.g. MyLogs\COM3__Exprecium\
Each log file is named as follows:
Year-Month-Day__Hour-Min.log e.g. 2004-06-12__13-00.log
Thus, it shows the date and time it was created.