User manual

A
A-3
Product Manager Messages
Message Are you sure you want to send firmware version?
Description Confirmation to send a firmware version to the switch.
Action Click Yes to confirm sending the firmware version to the switch, or no
to cancel the operation.
C
Message Cannot change Port Type while Management Style is FICON
without SANtegrity feature. Please contact your sales
representative.
Description Firmware level is 6.0 or less, and user attempted to change a port type
in the Configure Ports dialog box while FICON management style is
enabled, but the optional SANtegrity Binding feature is not installed.
Action Informational message. If firmware level is at 6.0 or below, install
SANtegrity Binding before changing port types in the Configure
Ports dialog box while using FICON management style.
Message Cannot disable Switch Binding while Enterprise Fabric Mode is
active and the switch is Online.
Description User attempted to disable switch binding through the Switch Binding
Change State dialog box, but Enterprise Fabric Mode is enabled.
Action You must either disable Enterprise Fabric Mode using the Enterprise
Fabric Mode dialog box in the EFC Manager application or set the
switch offline before you can disable Switch Binding.
Message Cannot disable Insistent Domain ID while Fabric Binding is active.
Description User attempted to disable the Insistent Domain ID parameter
through the Configure Switch Parameters dialog box, but Fabric
Binding is enabled.
Action Disable Fabric Binding through the Fabric Binding dialog box before
disabling these parameters.