User manual

2
2-170
Enterprise Operating System Command Line Interface User Manual
show
Output Example The show.port.opticEDD command output displays as follows:
Port Xvr Temp 3.3 Volt Current TX Power RX Power 1.8 Volt 5.0 Volt
---- --- ----- -------- ------- --------- --------- -------- -------
0 UNK Unknown Unknown Unknown Unknown Unknown Unknown Unknown
1 UNK Unknown Unknown Unknown Unknown Unknown Unknown Unknown
2 UNK Unknown Unknown Unknown Unknown Unknown Unknown Unknown
3 UNK Unknown Unknown Unknown Unknown Unknown Unknown Unknown
4 XFP 36.105 3.256 5.324 602.100 289.300 1.779 4.998
show.port.opticInfo
Syntax OpticInfo
Purpose This command displays information about the optic.
Parameters This command has no parameters.
Command Example
show port opticInfo
Output The port optic data is displayed as a table that includes the following
properties.
RX Pwr The Receiver power in uW.
1.8 Voltage The 1.8 Voltage in Volts.
5.0 Voltage The 5.0 Voltage in Volts.
Port The port number.
Xcvr The transceiver type.
Temp The optic temperature in Celsius.
3.3 Voltage The 3.3 Voltage in Volts.
Current The Current in mA.
TX Pwr The Transceiver power in uW.
RX Pwr The Receiver power in uW.
1.8 Voltage The 1.8 Voltage in Volts.
5.0 Voltage The 5.0 Voltage in Volts.