User manual

2
CLI Commands
2-121
perf
• Interval: 60 minutes
• State: Disabled
Parameters This command has one parameter.
TIP: Although the system supports a name length of 64 characters, you may want to
use a much shorter name. Some commands that display the threshold name show a
maximum of 51 characters. If you specify lengthy names, you can display the complete
name by entering the comma-delimited mode using the commaDelim command. For
more information, see Using the commaDelim Command on page 1-17.
Command Example Root> perf thresholdAlerts counter addAlert checklinks
perf.thresholdAlerts.counter.addPort
Syntax addPort name portNumber
Purpose This command adds a port to the specified counter threshold alert.
NOTE: An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
name Specifies the name of the new counter
threshold alert. This name can consist of any
ASCII characters up to a maximum length of 64
characters. To use spaces or special characters
in this name, put quotation marks around the
name. This parameter is case-sensitive.