User manual

2
2-52
E/OS Command Line Interface User Manual
config
received before the timeout. After the transmit attempt limit is
reached, the switch will, if applicable, move to the next defined
RADIUS server. The default number of attempts is three.
Parameters This command has two required parameters:
Command Example
Root> config security authentication RADIUS attempts 3 20
config.security.authentication.RADIUS.deadtime
Syntax deadtime minutes
Purpose This command configures the number of minutes a RADIUS server is
marked as “dead”. If a RADIUS server does not respond to an
authentication request, it can be marked as dead for a specified time
interval. This may speed up authentication by eliminating timeouts
and retransmissions. If no alternate RADIUS servers are available
(when only one server is configured or when all are marked dead),
then the deadtime is ignored. Deadtime may be 0 to 1440 minutes.
The default is 0.
Parameters This command has one required parameter:
Command Example
Root> config security authentication RADIUS deadtime 120
config.security.authentication.RADIUS.deleteServer
Syntax deleteServer index
Purpose This command removes a RADIUS server from the RADIUS server
list. If you delete a server, and there are servers configured in higher
index Index of the RADIUS sever (1-3) to change the
transmit attempts value.
attempts The number of transmit attempts. Valid values are
between 1 and 100.
minutes The number of minutes a RADIUS server is
marked “dead” before it is contacted again. Valid
values are between 0 and 1440.