User manual

2
2-50
E/OS Command Line Interface User Manual
config
NOTE: A preferred method of local and a backup method of RADIUS is not
an accepted combination because the local method can always be contacted.
Command Example Root> config security authentication interface cli
sequence RADIUS local
config.security.authentication.port.override
Syntax override portNumber [overrideState]
Purpose This command sets the outgoing override state for a single port. This
setting allows users to override the default outgoing authentication
state for either the E_Port or N_Port interface. The default setting will
cause the port to use the outgoing state configure for the
corresponding interface (E_Port or N_Port).
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
Parameters This command has one required parameter, and one optional
parameter:
portNumber Specifies the port number. Valid values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–15 for the Sphereon 4400
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the Sphereon 4700
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
overrideState This parameter sets the outgoing authentication
state for the specified port. Valid values are enable,
disable, or default. Boolean 1 and 0 values may also
be substituted.