User manual

2
CLI Commands
2-47
config
config.security.authentication.interface.osms.outgoing
Syntax outgoing enabledState
Purpose This command determines if outgoing authentication is used on all
OSMS requests. The OSMS key must be configured prior to setting
the outgoing state to enabled.
NOTE: The SANtegrity Authentication feature key must be installed to
configure the OSMS outgoing state.
Parameters This command has one parameter:
Command Example
Root> config security authentication interface osms
outgoing 1
config.security.authentication.interface.osms.setKey
Syntax setKey
Purpose This command sets the FCCT key that is associated with the single
OSMS username. This username is a static entry in the local
authentication database. This user is not viewable. This command
effectively sets the key that will be used in all OSMS authenticated
requests. This entry in the user database is only used for the OSMS
interface, and cannot be changed.
After issuing this command, users are directed to a password prompt
where they have to enter the actual 16-byte key. After entering the
new secret, they must confirm it in the following prompt. After
confirmation, they will be returned to the initial prompt that the
command was executed from.
No characters will be echoed back to the screen when entering a
password or when confirming a password.
enabledState This parameter enables and disables FCCT
authentication. Accepted values for this parameter
are enable or disable. Boolean 1 and 0 values may
also be substituted.