User manual

2
2-46
E/OS Command Line Interface User Manual
config
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
Parameters This command has one parameter:
Command Example
Root> config security authentication interface eport
outgoing disable
config.security.authentication.interface.nport.sequence
Syntax sequence method1 [method2]
Purpose This command sets the sequence that the N_Port interface will use to
authenticate. When the preferred method cannot be contacted, the
backup method will be used to authenticate the remote end of the
ISL.
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
Parameters This command has one required parameter, and one optional
parameter:
NOTE: A preferred method of local and a backup method of RADIUS is not
an accepted combination because the local method can always be contacted.
Command Example Root> config security authentication interface nport
sequence RADIUS local
enabledState This parameter enables and disables outgoing
CHAP authentication on all ISLs. Accepted values
for this parameter are enable or disable. Boolean 1
and 0 values may also be substituted.
method1 This sets the preferred method of authentication.
Accepted values are local or RADIUS.
method2 This optional parameter sets the backup method of
authentication. This backup method is used when
the preferred method cannot be contacted.
Accepted value is local.