User manual

2
CLI Commands
2-45
config
Command Example Root> config security authentication interface eport
outgoing disable
config.security.authentication.interface.eport.sequence
Syntax sequence method1 [method2]
Purpose This command sets the sequence that the E_Port interface will use to
authenticate. When the preferred method cannot be contacted, the
backup method will be used to authenticate the remote end of the
ISL.
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
Parameters This command has one required parameter, and one optional
parameter:
NOTE: A preferred method of local and a backup method of RADIUS is not
an accepted combination because the local method can always be contacted.
Command Example Root> config security authentication interface eport
sequence RADIUS local
config.security.authentication.interface.nport.outgoing
Syntax outgoing enabledState
Purpose This command determines if outgoing CHAP authentication is used
on N_Port connections. If this is enabled, the switch will issue a
CHAP challenge to authenticate the remote device.
method1 This sets the preferred method of authentication.
Accepted values are local or RADIUS.
method2 This optional parameter sets the backup method of
authentication. This backup method is used when
the preferred method cannot be contacted.
Accepted value is local.