User manual

2
2-42
E/OS Command Line Interface User Manual
config
Command Example Root> config port type 4 fport
config.security
Using the security command on the configuration branch, users can
enter the security configuration branch. All commands under this
branch operate on a particular security attribute.
Some security configuration commands (namely those under the
fabricBinding branch) are different from other CLI commands in that
they are not single action commands that take effect immediately.
These commands implement a rudimentary membership list editor.
A user works on a temporary copy of a membership list in the editor
and can perform actions such as adding or deleting fabric members.
The edited copy can then be activated to the fabric.
It should be noted that not all verification of membership lists can be
made in the pending copy. Therefore, it is possible that a user will
build up a pending membership list definition without errors, but
will encounter errors when saving to the fabric. It should also be
noted that the state of the pending configuration must be set to
restrict in order to make any changes to the (pending) fabric
membership list.
config.security.authentication.interface
Using this command, the authentication interface is configured for
Web and CLI users, OSMS, and devices. The authentication has two
interfaces namely, Local and Radius, which can be used in three
combinations namely, Local, Radius, and Radius then Local.
portType Specifies the type of the port. Valid values for the port
type are:
eport
fport
gport
fxport (Sphereon 4300 and Sphereon 4500 only)
gxport (Sphereon 4300 and Sphereon 4500 only)