User manual

2
CLI Commands
2-39
config
NOTE: Port speed changes temporarily disrupt port data transfers.
Parameters This command has two required parameters:
Command Examples
Root> config port speed 4 2g
Root> config port speed 6 negotiateBurst4gMax
portNumber Specifies the port number. Valid values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016
0–16 for the Sphereon 4400
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032
0–32 for the Sphereon 4700
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
portSpeed Specifies the speed of the port. Valid values are
1g
2g
4g
Negotiate
4gSustained
4gBurst
negotiateSustained
negotiateBurst4gMax
negotiate2gMax
Note: 4gBurst and negotiateBurst4gMax are applied
only to F_port type on QPM cards. To configure to
these port speed, you will need to first set the port to
F_port.