User manual

2
CLI Commands
2-27
config
config.NPIV.setState
Syntax setState NPIVEnabledState
Purpose This command sets the enabled state of the NPIV feature. The NPIV
feature key must be installed in order to enable this feature.
Parameters This command has one parameter:
Command Example
Root> config NPIV setState enable
config.NPIV.show
Syntax show
Purpose This command displays the current NPIV configuration for all ports.
Parameters This command has no parameters.
Command Example
Root> config NPIV show
Output This command displays the following NPIV configuration data:
Output Example The output from the config.NPIV.show command appears as follows:
NPIV state:Enabled
Port Max Allowed NPIV Logins
---------------------------
110
210
310
40
50
6 130
...
NPIVEnabledState This parameter can be set to enable or disable.
Boolean 1 and 0 values may also be substituted.
NPIV state The current enabled/disabled state of the NPIV feature.
Max Allowed NPIV Login Table. A table mapping each port number
on the switch to a corresponding max number of NPIV
logins setting.