User manual

2
CLI Commands
2-25
config
Purpose This command sets the Ethernet line speed.
Parameters This command has two parameters. One of the parameters is optional
depending on the combination.
Command Example
Root> config ip lineSpeed 10 half
config.ip.show
Syntax show
Purpose This command shows the LAN configuration.
Parameters This command has no parameters.
Command Example
Root> config ip show
Output The LAN configuration data is displayed as a table that includes the
following properties.
Output Example The output from the config.ip.show command appears as follows:
IP Address: 10.0.0.0
Gateway Address: 0.0.0.0
Subnet Mask: 255.0.0.0
config.NPIV
N_Port ID Virtualization (NPIV) provides an FC facility for sharing a
single physical N_Port among multiple N_Port IDs, thereby allowing
multiple initiators, each with its own N_Port ID, to share the N_Port.
speed The line speed. Options are auto, 10, or 100. If auto
is entered then the optional duplex should not be
entered.
duplex The duplex mode for the connection. Options are
full or half.
IP Address The IP address.
Gateway Address The gateway address.
Subnet Mask The subnet mask.