User manual

2
2-24
E/OS Command Line Interface User Manual
config
Output The data is displayed as a table that includes the following
information:
Output Example The output from the config.ficonMS.show command appears as
follows:
Ficon MS State: Disabled
Ficon MIHPTO (seconds): 180
config.ip.ethernet
Syntax ethernet ipAddress gatewayAddress subnetMask
Purpose This command sets the Ethernet network settings. If the IP address is
reconfigured, the Telnet client must be reconnected to the new IP
address. A new login will be requested.
NOTE: The Telnet connection can be lost when these Ethernet network
settings are changed.
Parameters This command has three parameters:
Command Example
Root> config ip ethernet 10.0.0.0 0.0.0.0 255.0.0.0
config.ip.lineSpeed
Syntax lineSpeed speed duplex
Ficon MS State The state of the FICON MS feature.
Ficon MIHPTO The FICON MIHPTO value in seconds.
ipAddress Specifies the new IP address for the director or
switch. The address must be entered in dotted
decimal format (for example, 10.0.0.0).
gatewayAddress Specifies the new gateway address for the Ethernet
interface. The address must be entered in dotted
decimal format (for example, 0.0.0.0).
subnetMask Specifies the new subnet mask for the Ethernet
interface. The address must be entered in dotted
decimal format (for example, 255.0.0.0).