User manual

2
CLI Commands
2-15
config
Parameters This command has two parameters:
NOTE: A range of ports is not accepted as a valid input to this command
(e.g., “0-29” is not acceptable).
The port values can also be substituted with one of the following
keywords that will remove all the ports from the alert, and then use a
specific type of port instead of individual port numbers.
Valid values are:
• eport – This adds all active E_ports.
• fport – This adds all active F_ports.
• flport – This adds all active F_Ports and FL_ports (This applies to
Sphereon 4400, Sphereon 4300, Sphereon 4500 and Sphereon 4700
switches).
NOTE: A fencing policy can contain either port types or individual port
numbers only.
Command Example Root> config fencing addPort 24
Root> config fencing addPort eport
name The name of the fencing policy.
portNumber The port number to add to the fencing policy, or
all, which will add all of the individual ports to the
fencing policy. Valid values for the port number
are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016
0–15 for the Sphereon 4400
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032
0–31 for the Sphereon 3232
0–31 for the Sphereon 4700
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140