User manual

2
2-254
E/OS Command Line Interface User Manual
show
Output Example The output from the show.thresholdAlerts.alerts command appears as
follows:
Name Type State
------------------------------------ ----------------- --------
Throughput Threshold #1 Rx Util Enable
Threshold for CRC CRC Errors Disabled
Safety #2 Logic Lnk Err Set Enabled
Safety #1 Cls2 BusiedFrms Disabled
show.thresholdAlerts.log
Syntax log [clear]
Purpose This command shows the contents of the threshold alert log. This log
shows all the threshold alerts that have been triggered, including
both counter threshold alerts (CTAs) and throughput threshold alerts
(TTAs).
ATTENTION! If the switch is restarted (as occurs during IPL, IML,
configuration reset, feature key installation, or firmware load) or is power
cycled, the information in the threshold alert log is lost.
Parameters This command has one parameter:
Command Example
Root> show thresholdAlerts log
Output The threshold alert log data appears as a table that includes the
following properties:
clear This optional parameter causes all threshold log
entries to be cleared.
Date/Time The date and time of the alert.
Name The name of the threshold alert, truncated to 22
characters.
Port The type of threshold alert (CTAs only).
Type The trigger statistic or threshold type of the alert
(abbreviated to 17 characters). These include:
Tx Util TTA - Transmit Utilization.
Rx Util TTA - Receive Utilization.