User manual

2
CLI Commands
2-251
show
Output Example The output from the show.system command appears as follows:
System Information
Name: Joe's Switch
Description: McDATA ED-6064 Fibre Channel Director
Contact: Joe
Location: Everywhere
Date/Time: 04/16/2001 10:34:01AM
Serial Number: 82420481
Type Number: 006064
Model Name: ED-6064
Model Number: 001
EC Level: 1011231
Firmware Version: 04.01.00 Build 23
Beaconing: Disabled
show.syslog
Syntax syslog
Purpose This command displays the syslog configuration
Parameters This command has no parameters.
Output The syslog configuration is shown as a table of properties. The
following properties are displayed:
Firmware Version The current firmware version installed.
Beaconing The enabled state of unit beaconing (enabled or
disabled) as set in the maint.system.beacon
command.
Date/Time The system date and time as set in the
config.system.date command. For more information,
see config.system.date on page 2-121.
Log The index number of the server.
State Reports if syslog support is enabled.
Index The index number of the server.
IP Address The IP address of the server.
Facility The facility level for the server. Values are Local 0 - Local 7.