User manual

2
CLI Commands
2-249
show
Output Example The output from the show.switch command appears as follows:
Show> switch
State: Online
R_A_TOV: 20
E_D_TOV: 4
Preferred Domain Id: 1
Switch Priority: Default
Speed: 2 Gb/sec
Rerouting Delay: Enabled
Interop Mode: Open Fabric 1.0
Active Domain Id: 1
World Wide Name: 10:00:08:00:88:00:21:07
Insistent Domain Id: Enabled
Domain RSCN: Enabled
Zoning RSCN: Disabled
FC Address Domain Id: 67 (hexadecimal)
Limited Fabric RSCN: Disabled
Safe Zoning: Enabled
ISL FSPF Cost: By Port Speed
FC Address
Domain Id
The domain ID of the switch derived from the Fibre
Channel Address.
Limited Fabric
RSCN
When enabled, fabric RSCNs are suppressed after an
IPL.
Isolate Zone RSCN When set to fabric filtering, fabric RSCNs will only be
sent to those members that need notification. When
set to No Filtering, RSCNs will be set to everyone
when zoning information changes.
Safe Zoning Safe zoning state.
ISL FSPF Cost The method for computing the FSPF cost for ISLs.
Web Enable The enabled state of web.
API Enable The enabled state of API.
API Management
IP
IP address for of where the application that is
managing the switch or director resides. If there is no
application managing the switch, this will be the IP
address of the switch.
HA Mode The enabled state of HA mode.
Domain ID Offset The configured Domain ID offset of the switch
Password Exp.
Time
The configured password expiration time for the
management interface users of the switch.