User manual

2
CLI Commands
2-247
show
Output Example The output from the show.snmp.config command appears as follows:
SNMP Agent State: Enabled
SNMPv3 State: Disabled
FA MIB Version Number: 3.0
Authentication Traps: Enabled
Index Community Name WriteAuth Trap Recipient UDP Port
----- -------------------------------- --------- --------------- --------
1 CommunityName1 Enabled 123.123.123.123 162
2 CommunityName2 Enabled 10.25.25.10 144
3 CommunityName3 Disabled 132.44.85.224 162
4 public Enabled 162
5
6
show.switch
Syntax switch
Purpose This command displays the switch attributes.
Parameters This command has no parameters.
Command Example
Root> show switch
Output The switch attributes data is displayed as a table that includes the
following properties:
Authentication Traps Displays the state of authentication traps to be sent
to SNMP management stations when unauthorized
stations try to access SNMP information from the
switch or director.
Index Index in the community table.
Community. Name Displays the community name.
WriteAuth The write authorization state of the community.
Trap Recipient Protocol description of the trap recipient.
UDP Port UDP port number to which the switch or director
will send traps for each recipient. This value is
expressed in decimal and the default value is 162.