User manual

2
2-246
E/OS Command Line Interface User Manual
show
Output Example The output from the show.snmp.viewTable command appears as
follows:
View Name Type Object ID
-------------------------------- ------------------ ---------
no_access View Excluded .1.3.6.1
internet View Included .1.3.6.1
management View Included .1.3.6.1.2
experimental View Included .1.3.6.1.3
private View Included .1.3.6.1.4
snmpv3 View Included .1.3.6.1.6
fceos View Included .1.3.6.1.4.1.289
fcmgmt_3_1 View Included .1.3.6.1.2.1.8888
fcmgmt_3_0 View Included .1.3.6.1.3.94
fcfe View Included .1.3.6.1.3.42
system View Included .1.3.6.1.2.1.1
ip View Included .1.3.6.1.2.1.4
NOTE: The command config.snmp.showViewTable on page 22-101 has
functionality that is the same as this command.
show.snmp.config
Syntax config
Purpose This command displays the switch SNMP configuration.
Parameters This command has no parameters.
NOTE: The command config.snmp.show on page 2-96 has functionality that is
identical to this command.
Command Example Root> show snmp config
Output The switch configuration data is displayed as a table that includes the
following properties:
SNMP Agent State Displays the state of the SNMP agent. If it is
disabled, then the SNMP state will not respond to
any requests, nor will it produce any traps.
SNMPv3 State The SNMPv3 state.
FA MIB Version
Number
Version of the Fibre Alliance MIB (FA MIB) that the
SNMP agent is configured to use.