User manual

2
2-244
E/OS Command Line Interface User Manual
show
Output This command displays the following switch configuration data:
Output Example The output from the show.snmp.userTable command appears as
follows:
SNMPv3 State: Enabled
Index Username Auth Protocol Privacy Protocol
----- -------------------------------- ----------------- ----------------
1 User1 No Authentication No Privacy
2 User2 HMAC-MD5 No Privacy
3 User3 HMAC-SHA DES
4
5
6
NOTE: This command and the command config.snmp.showUserTable on
page 22-100 has the same functionality.
show.snmp.V3GroupTable
Syntax V3GroupTable
Purpose Displays the Security-to-Group table.
Parameters This command has no parameters.
Command Example
Root> show snmp v3GroupTable
SNMPv3 State Indicates the status of SNMPv3 (Enabled or
Disabled).
Index The index number.
Username The username.
Auth Protocol The Authentication Protocol.
Privacy Protocol The Privacy Protocol.