User manual

2
2-242
E/OS Command Line Interface User Manual
show
Config.SNMP> showAccessTable 1
Index: 1
Security Model: Any
Security Level: None
Group Name: group1
Read View: fcmgmt_3_1
Write View: fceos
Notify View: internet
NOTE: The command config.snmp.showAccessTable on page 22-97 has the
functionality that is the same as this command.
show.snmp.targetTable
Syntax tagetTable [index]
Purpose This command displays the configured values for the Target Table.
Parameters This command has one optional parameter:
Command Example
Root> show snmp tagetTable
Output Example The output from the show.snmp.targetTable command appears as
follows:
SNMPv3 State: Enabled
Index Target IP UDP Port Community MP Model
----- ------------- -------- --------------------------------- --------
1 172.19.16.169 162 public SNMPv1
2
3
4
5
6
If the optional parameter, index, is specified, the output from this
command contains the following information:
Security Model The security model.
Security Level The security level.
Read View The read view name.
Write View The write view name.
Notify View The notify view name.