User manual

2
CLI Commands
2-235
show
Parameters This command has the following parameters:
Output The output from the show.preferredPath.showPath command includes
the following parameters:
destDomainId Specifies the destination domain ID. Valid domain
IDs are in the range 1–31 or all, which shows all paths
to and from the source port specified in the
sourcePort parameter.
sourcePort Specifies the number of the source port. Valid port
numbers values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–15 for the Sphereon 4400
0–23 for the Sphereon 4500
0-31 for the Sphereon 4700
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
Or, you can specify all to show all paths to the
destination domain ID specified for the
destDomainId parameter.
Destination
Domain
The destination domain ID to which a preferred path
has been configured. This is displayed only if the
destination domain parameter is set to all.
Source Port The source port for which a preferred path to the
specified destination domain ID is specified. This is
displayed only if the source port parameter is set to
all.
Preferred Exit Port The configured preferred path exit port. This value
can be any port number, or blank to indicate that no
preferred path has been configured.
Actual Exit Port This is the actual exit port being used for the given
path.