User manual

2
2-234
E/OS Command Line Interface User Manual
show
Output Example The output from the show.port.technology command appears as
follows:
Port Connectr Transcvr Distance Media
---- -------- --------- ------------ -----------
0 LC Long LC Long M-M 50um
1 LC Long LC Long M-M 50um
2 LC Long LC Long M-M 50um
3 MT_RJ Long LC Long M-M 50um
4 MT_RJ Long LC Long M-M 50um
5 MT_RJ Long LC Long M-M 50um
6 LC Long LC Long M-M 50um
7 LC Long LC Long M-M 50um
8 LC Long LC Long M-M 50um
9 LC Long LC Long M-M 50um
10 LC Long LC Long M-M 50um
11 LC Long LC Long M-M 50um
12 LC Long LC Long M-M 50um
13 LC Long LC Long M-M 50um
14 LC Long LC Long M-M 50um
15 LC Long LC Long M-M 50um
show.preferredPath.showPath
Syntax showPath destDomainID sourcePort
Purpose This command displays the specified preferred path configuration
and the actual path used by the system. The output shows both the
exit port as configured for the preferredPath feature and the actual
exit port currently being used for traffic.
Use all for one of the command’s parameters to display all configured
and actual exit ports for either the destination domain ID or the
specified source port. You cannot specify all for both parameters. If
the destination domain is set to all, all paths from the specified source
port are displayed. If the source port is set to all, the output shows all
source port paths to the specified domain.
Media The media type (M-M 62.5um, M-M 50um, M-M
50,62.5um, S-M 9um, Copper).