User manual

2
CLI Commands
2-233
show
Output Example The output from the show.port.status command appears as follows:
Port State Type Attached WWN Beaconing Reason
---- ---------------- ----- ----------------------- --------- ------
0 Online fPort 10:00:80:00:11:22:33:44 Off
1 Online gPort 10:00:80:00:11:22:33:45 On
2 No Light fPort 10:00:80:00:11:22:33:55 On
3 Offline ePort 10:00:80:00:11:22:33:00 Off
4 Online gPort 10:00:80:00:11:22:33:57 Off
5 Port Failure fPort 10:00:80:00:11:22:33:46 Off
6 Link Reset gPort 10:00:80:00:11:22:33:63 Off
7 Segmented E_Port ePort 10:00:80:00:11:22:33:47 Off 02
8 Online ePort 10:00:80:00:11:22:33:88 Off
9 Offline fPort 10:00:80:00:11:22:33:49 Off
10 Inactive ePort 10:00:80:00:11:22:33:50 Off 26
11 Online fPort 10:00:80:00:11:22:33:53 Off
12 No Light fPort 10:00:80:00:11:22:33:56 Off
13 Online fPort 10:00:80:00:11:22:33:59 Off
14 Invalid Attachment fPort 10:00:80:00:11:22:33:64 Off 15
15 Online fPort 10:00:80:00:11:22:33:66 Off
02: Duplicate Domain ID(s)
03: Switch Speed Conflict
07: ISL connection not allowed on this port
show.port.technology
Syntax technology
Purpose This command displays port technology information for all ports.
Parameters This command has no parameters.
Command Example
Root> show port technology
Output The port technology data is displayed as a table that includes the
following properties:
Port The port number.
Connectr The port connector type (LC, MT_RJ, MU, Internal).
Transcvr The transceiver type (Long LC, Short, Short OFC,
Long LL, Long Dist).
Distance The distances supported (Short, Intermediate, Long,
Very Long).