User manual

2
CLI Commands
2-229
show
Output Example The output from the show.port.profile command appears as follows:
Port Number: 4
Name: Sam's tape drive
Blocked: False
Blocked Reason:
Operating Type: FL Port
Operating Speed: 2G
Port WWN: A2:33:15:C3:3F:00:00:0A
Configured Type: Gx_Port
Configured Speed: Neg
Beaconing: Disabled
FAN: Disabled
FC Address: 034FA2
Attached WWN: F0:01:02:A1:B0:22:00:12
Operational State: Online
Reason: None
Rx BB_Credits: 12
Connector Type: LC
Transceiver: Long LC
Distance Capability: Long
Media Type: M-M 50um
Speed Capability: 2 Gb/sec
10G FC Compliance: None
show.port.showPortAddr
Syntax showPortAddr
Purpose This command displays the port address configuration for all ports.
NOTE: The config.port.showPortAddr on page 2-36 has functionality that is
identical to this command.
Parameters This command has no parameters.
Command Example
Root> show port showPortAddr
Output The port configuration is shown as a table of properties. The
following properties are displayed:
Port The port number.