User manual

2
2-224
E/OS Command Line Interface User Manual
show
Output This command displays the following optic data:
NOTE: If an Alarm and a Warning threshold have both been exceeded, then
the Alarm state will be displayed because it is of high priority.
Command Example Root> Show Port opticHealth
Output Example The show.port.opticHealth command output appears as follows:
Port Transceiver Overall Health
---- ----------- --------------
0 XPM Normal
1 (Unaddressable)
2 (Unaddressable)
3 (Unaddressable)
4 SFP Normal
5 Unk No Info
6 Unk No info
7 SFP Warning
8 SFP Alarm
...
show.port.opticInfo
Syntax OpticInfo
Purpose This command displays information about the optic.
Parameters This command has no parameters.
Command Example
Root> show port opticInfo
Port The port number.
Overall Health The overall health of the optic. Possible values are
list below according to priority.
Alarm One or more alarm threshold has been exceeded.
Warning One or more warning threshold has been exceeded.
Normal All measurements are within thresholds.
No Info The optic does not support enhanced digital
diagnostics or the state has not been updated yet.