User manual

2
2-220
E/OS Command Line Interface User Manual
show
Parameters This command has one parameter:
Command Example
Root> show port nodes portNumber
Output The port nodes data is displayed as a table that includes the following
properties:
portNumber Specifies the port number. Valid values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 4400
0–23 for the Sphereon 4500
0–31 for the Sphereon 4700
FC Addr The Fibre Channel address of nodes attached to this
port. Private devices are assigned address strings of
0000 followed by the two-digit hexadecimal
Arbitrated Loop Physical Address (AL_PA), instead
of the 6 digit hexadecimal number presented for
public devices.
BB Crdt Represents the maximum number of outstanding
frames which can be transmitted without causing a
buffer over-run condition at the receiver.
RxFldSz Buffer-to-buffer Receive Data Field Size from the
FLOGI received from the attached N_Port.
COS Class of service: 1; 2; 3; 4; 5; 6; F; 1,2; 2,3…
Port Name The port worldwide name of the attached device.
Node Name The node worldwide name of the attached device.