User manual

2
CLI Commands
2-215
show
Output The port configuration attributes are displayed as a table that
includes the following properties:
Output Example The output from the show.port.config command appears as follows:
Port Name Blocked Type Speed Rx Crdts
---- ------------------------ --------- ------ --------------- --------
0 port_0_name Blocked gxPort Neg Sust 12
1 Blocked gxPort Neg Burst 12
2 Blocked gxPort Neg Burst 12
3 Blocked gxPort Neg Burst 12
...
Port The port number.
Name The name of the port as set in the config.port.name
command.
Blocked The blocked state of the port as set in the
config.port.blocked command.
FAN The configured Fabric Address Notification (FAN)
state. (Sphereon 4300, Sphereon 4500, Sphereon 4400,
and Sphereon 4700 switches only).
Type The port type as set in the config.port.type command.
Speed The configured port speed.
1G – 1 Gb/sec
2G – 2 Gb/sec
4G – 4 Gb/sec (Sphereon 4400 and Sphereon 4700 only)
10G – 10 Gb/sec (XPM only)
Neg – Negotiate
4G Sust – 4 Gb/sec Sustained (QPM only)
4G Burst – 4 Gb/sec Burst (QPM only)
Neg Sust – Negotiate Sustained (QPM only)
Neg 2G Max – Negotiate 2 Gb/sec Maximum (QPM only)
Neg B 4G Max – Negotiate Burst 4 Gb/sec Maximum
(QPM only)
Rx Crdts The number of Rx BB_Credits as set in the
config.port.rxCredits command.