User manual

2
2-214
E/OS Command Line Interface User Manual
show
Parameters This command has one optional parameter:
Command Example
show opentrunking reroutelog
NOTE: The clear parameter also clears the log entries for your SAN
management application.
Output The device information data is displayed as a table that includes the
following properties:
Output Example The output from the show.opentrunking.reroutelog command appears
as follows:
Date/Time RcvPort Dom OldExit NewExit
--------------- ------- --- ------- -------
04/12/01 10:58A 63 2 41 42
03/23/02 12:01P 4 3 35 36
show.port.config
Syntax config
Purpose This command shows the port configuration for all ports.
Parameters This command has no parameters.
Command Example
Root> show port config
clear This optional parameter causes all re-route log
entries to be cleared.
Date/Time The date/time when the rerouting event occurred.
Rcv The port associated with the flow that was rerouted.
Dom The target domain associated with the flow that was
rerouted.
Old The exit port number on this switch that the flow
used to get to the target domain.
New The exit port number on this switch that the flow
now uses to get to the target domain.