User manual

2
CLI Commands
2-213
show
Output The device information is displayed as a table that includes the
following:
Output Example The output from the show.openTrunking.config command appears as
follows:
Unresolved Congestion: Enabled
Backpressure: Disabled
Low BB_Credit Threshold (%): 75 (default)
Port Threshold %
---- ------------
1 60 (default)
2 69
3 60 (default)
4 60 (default)
5 90
680
...
show.openTrunking.rerouteLog
Syntax reroutelog [clear]
Purpose This command displays the Open Trunking Re-route Log
information.
ATTENTION! If the switch is restarted (as occurs during IPL, IML,
configuration reset, feature key installation, or firmware load) or is power
cycled, the information in the Open Trunking Re-route Log is lost.
Unresolved
Congestion
The current enabled/disabled state of the unresolved
congestion trunking feature.
Backpressure The current enabled/disabled state of the
backpressure trunking feature.
Low BB_Credit
Threshold
The current threshold setting of the low BB_Credit
threshold trunking feature listed as a percentage. If
this value is configured to be the default, (default)
is displayed alongside the threshold value. The
default value is 75%.
Congestion
Threshold Table
A table mapping each port number on the switch to a
corresponding threshold setting. The threshold is
listed as a percentage. If this value is configured to be
the default, (default) is displayed alongside the
threshold value. The default value is 60%.