User manual

2
2-208
E/OS Command Line Interface User Manual
show
Show> nameServer
DID Type PortId Port Name Node Name COS FC4
--- ---- ------ ----------------------- ----------------------- --- ---
28 F 7C3913 10:00:00:00:C9:20:DA:D1 20:00:00:00:C9:20:DA:D1
FC4 types decode information can be viewed via the show nameserverFC4Types CLI
command
Show> nameServer 15 (15 is not in the fabric)
No entries in the database for Domain 15.
show.nameServerExt
Syntax nameServerExt
Purpose This command displays extended information from the nameserver
database for devices attached to this switch. The command provides
symbolic nameserver information, as well as the same information as
the show.nameServer command. Multiple devices per port are possible
for any public loop device attached to an FL_Port.
NOTE: Because it contains symbolic nameserver information that can be
lengthy, the CLI output wraps several times per node. For this reason, this
command is supported only in comma-delimited mode. For more
information about the comma-delimited mode, see Using the commaDelim
Command on page 1-19.
Parameters This command has no parameters.
Command Example
Root> show nameServerExt
Output The device information data is displayed as a table that includes the
following properties:
Type The type (N, NL, F/NL, F, FL, E, B).
Port Id The 24-bit Fibre Channel address.
Port Name The port WWN of the attached device.
Node Name The node WWN of the attached device.
COS The class of service (for example, 1; 2; 3; 4; 5; 6; F; 1,2;
2,3).