User manual

2
CLI Commands
2-207
show
Output The device information data is displayed as a table that includes the
following properties:
Output Example The output from the show.nameServer command appears as follows:
Show> nameServer all
DID Type PortId Port Name Node Name COS FC4
--- ---- ------ ----------------------- ----------------------- --- ---
1 F 613613 50:06:04:8A:CC:C8:61:51 50:06:04:8A:CC:C8:61:51
1 F 613B13 10:00:00:00:C9:20:DB:1F 20:00:00:00:C9:20:DB:1F
21 F 753713 50:06:04:8A:CC:C8:61:50 50:06:04:8A:CC:C8:61:50
28 F 7C3913 10:00:00:00:C9:20:DA:D1 20:00:00:00:C9:20:DA:D1
12 F 6C3A13 10:00:00:00:C9:20:DB:10 20:00:00:00:C9:20:DB:10
FC4 types decode information can be viewed via the show nameserverFC4Types CLI
command
Show> nameServer 1
DID Type PortId Port Name Node Name COS FC4
--- ---- ------ ----------------------- ----------------------- --- ---
1 F 613613 50:06:04:8A:CC:C8:61:51 50:06:04:8A:CC:C8:61:51
1 F 613B13 10:00:00:00:C9:20:DB:1F 20:00:00:00:C9:20:DB:1F
FC4 types decode information can be viewed via the show nameserverFC4Types CLI
command
DID The DID of the switch whose nameserver entries are
being displayed.
Type The type of the port (N, NL, F/NL, F, FL, E, B).
Port Id The 24-bit Fibre Channel address.
Port Name The port WWN of the attached device.
Node Name The node WWN of the attached device.
COS The class of service (for example, 1; 2; 3; 4; 5; 6; F; 1,2;
2,3).
FC4 Types The FC4 types registered for this device. One or more
numbers display in this field. The numbers in this
field correspond to the list at the bottom of the output
example below.
Note: There can be multiple FC4 types for each
device. Since this is very rare, the CLI may wrap in
the event that more than two are registered for this
device.