User manual

2
2-206
E/OS Command Line Interface User Manual
show
Output Example The output from the show.loginServer command appears as follows:
Port BB Crdt RxFldSz COS Port Name Node Name
---- ------- ------- --- ----------------------- -----------------------
0 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
1 10 2 00:11:22:33:44:55:00:78 20:11:22:33:44:55:66:78
4 10 2,3 00:11:22:33:44:55:00:79 20:11:22:33:44:55:66:79
7 10 2,3 00:11:22:33:44:55:00:80 20:11:22:33:44:55:66:80
8 10 2 00:11:22:33:44:55:00:81 20:11:22:33:44:55:66:81
10 10 2,3 00:11:22:33:44:55:00:82 20:11:22:33:44:55:66:82
11 10 2,3 00:11:22:33:44:55:00:83 20:11:22:33:44:55:66:83
12 10 3 00:11:22:33:44:55:00:84 20:11:22:33:44:55:66:84
13 10 2,3 00:11:22:33:44:55:00:85 20:11:22:33:44:55:66:85
15 10 2,3 00:11:22:33:44:55:00:86 20:11:22:33:44:55:66:86
show.nameServer
Syntax nameServer DID
Purpose This command displays information from the nameserver database
for devices attached to this switch when DID is not specified. If DID
is specified, the local nameserver database entries for the specified
domain are displayed. If the parameter is "all", then all of the
nameserver database entries for all the domains in the fabric will be
displayed. Note that it is possible to have more than one device per
port for any public loop devices attached to an FL_Port.
Parameters This command has one optional parameter.
Command Example
Root> show nameServer
COS The class of service (for example, 1; 2; 3; 4; 5; 6; F; 1,2;
2,3).
Port Name The port WWN of the attached device.
Node Name The node WWN of the attached device.
DID The DID of the switch whose nameserver database
information is to be displayed. This parameter can
also be all.