User manual

2
2-204
E/OS Command Line Interface User Manual
show
Purpose This command displays Ethernet attributes.
Parameters This command has no parameters.
Command Example
Root> show ip ethernet
Output The Ethernet attributes data is displayed as a table that includes the
following properties:
Output Example The output from the show.ip.ethernet command appears as follows:
LAN Information
IP Address: 144.49.10.15
Gateway Address: 144.49.10.1
Subnet Mask: 255.255.255.0
show.linkIncidentLog
Syntax linkIncidentLog [clear]
Purpose This command displays the contents of the link incident log on the
director or switch.
ATTENTION! If the switch is restarted (as occurs during IPL, IML,
configuration reset, feature key installation, or firmware load) or is power
cycled, the information in the link incident log is lost.
Parameters This command has one optional parameter:
Command Example
Root> show linkIncidentLog
IP Address The IP address for the Ethernet adapter as set in the
config.ip.ethernet command.
Gateway Address The gateway address for the Ethernet adapter as set
in the config.ip.ethernet command.
Subnet Mask The subnet mask for the Ethernet adapter as set in the
config.ip.ethernet command.
clear This optional parameter causes all link incident log
entries to be cleared.