User manual

2
CLI Commands
2-199
show
show.features
Syntax features
Purpose This command displays a table of all installed feature sets and their
states. This command provides the same output as the command
config.features.show on page 2-12.
Parameters This command has no parameters.
Command Example
Root> show features
Output The features data is displayed as a table that includes the following
properties:
Output Example The output from the show.features command appears as follows:
Installed Feature Set Feature State Exp
------------------------------ ------------------------------ -------- -----
Security Package
SANtegrity Binding Switch Binding Enabled
SANtegrity Binding Fabric Binding Active
SANtegrity Binding Enterprise Fabrics Active
SANtegrity Authentication SANtegrity Authentication Enabled
FICON Cascading Bundle
FICON Management Server FICON Management Server Enabled
FICON CUP Zoning FICON CUP Zoning Active
OpenTrunking OpenTrunking Active
NPIV Trial* NPIV Trial* Enabled* 27*
Installed Feature
Set
The feature set installed using a feature key. Only
installed keys are displayed.
Feature Individual features within each set. In many cases,
there is only one feature within each feature set.
State The state of the individual feature. Fabric-wide
features are displayed as Active/Inactive.
Switch-centric features are displayed as
Enabled/Disabled.
Exp The remaining evaluation time in days for the trial
feature.