User manual

2
CLI Commands
2-197
show
Output
Output Example Show.Fabric> traceroute 50:06:04:8D:C7:DF:AE:A0
50:06:04:8D:C7:DF:AE:9F
Return code: Command Completed Successfully
Number of Entries: 6
Entry 0
Switch WWN: 10:00:08:00:88:60:F0:A2
Return code The return value. Possible values are:
• Command Completed Successfully
• Command Not Supported in Next Switch
• No Response from Next Switch
• Maximum Hop Count Reached
• Source Port not in Fabric
• Destination Port not in Fabric
• Devices not in Common Zone
• No Route Between Designated Ports
• No Additional Explanation
• Fabric Busy
• Fabric Build in Progress
• Unable to run a trace route at this time
Number of Entries The number of entries returned from the trace
route.
Switch WWN The switch WWN at that point in the trace route.
Domain ID The switch Domain ID at that point in the trace
route.
Ingress Port WWN The Ingress Port WWN taken by the trace route.
Ingress Port Num The Ingress Port Num taken by the trace route.
Egress Port WWN The Egress Port WWN taken by the trace route.
Egress Port Num The Egress Port Num taken by the trace route.
Direction The direction the trace route was going for the
specified entry. Possible values are:
• Source to destination
• At Destination
• Destination to source